ac output for r?sistive loads. 8,5-30 vdc control voltage with led. ? protection ip10 optional (1k199 000). ?sortie ac pour charges r?sistives. ?commande 8,5-30 vdc avec led. ?possibilit? de protection ip10 en option:capot 1k199 000. page 1 / 2 f/gb s/tri/SGT962360/b/7/05/2002 relais statique triphas? three phase solid state relays SGT962360 24 to 600 vac - 25 arms all technical caracteristics are subject to change without previous notice. caract?ristiques sujettes ? modifications sans pr?avis. celduc ? r e l a i s circuit ?quivalent/ equivalent circuit : dimensions / dimensions : 39,5 73,5 40 91 100 82, 7 4,4 19 19 58,4 23 2t1 4t2 6t3 1l1 3l2 5l 3 a2 a1 + - r s t resistive or inductive load rs t rs t m led adaptateur / ada p ter adaptateur / adapter adaptateur / ada p ter a2 - a1 + 1l1 3l2 5l3 2t1 4t2 6t3 application typique / typical application : proud to serve you caract?ristiques de commande (? 20 c) / control characteristics (at 20 c) dc param?tre / parameter symbol min nom max unit tension de commande / control voltage uc 8,5 24 30 v courant de commande / control current (@ uc ) ic 10 35 45 ma tension de relachement/ release voltage uc off 4 v r?sistance interne / input internal resistor fig.1 rc 620 ? tension inverse / reverse voltage urv 30 v caract?ristiques d'entr?e-sortie (? 20 c) / input-output characteristics (at 20 c) isolement entr?e-sortie/ input-output isolation @500m ui 4000 vrms isolement sortie-semelle/ output-case isolation @500m ui 2500 vrms tension assign?e isolement/ rated impulse voltage uimp 4000 v caract?ristiques g?n?rales / general characteristics param?tre / parameter conditions symbol typ. unit poids/ weight 370 g plage de temp?rature de stockage / storage temperature range -40 / +100 c plage de temp?rature de fonctionnement/ operating temperature range -40 / +100 c 0 2 4 6 8 10 12 14 16 18 20 22 24 26 28 30 0 0 10 20 30 40 50 0 uc(v) ic(ma) fig. 1 :caract?ristique d'entr?e / control characteristic
0 10 20 30 40 5 0 60 70 80 90 100 ambient temperature (?) without heatsink 1,2k/w 0 , 9k/w 0,55k/w 0 5 10 15 20 25 0 10 20 30 40 50 60 70 80 90 100 110 rms load current ( a ) total wasted power (w) full on-state r e l a i s rue amp?re b.p. 4 42290 sorbiers - france e-mail : celduc-relais@celduc.com fax +33 (0) 4 77 53 85 51 service commercial france t?l. : +33 (0) 4 77 53 90 20 sales dept.for europe tel. : +33 (0) 4 77 53 90 21 sales dept. asia : t?l. +33 (0) 4 77 53 90 19 www.celduc.com celduc ? pr?cautions : * les relais ? semiconducteurs ne procurent pas d'isolation galvanique entre le r?seau et la charge. cautions : * semiconductor relays don't provide any galvanic insu- lation between the load and the mains. page 2 / 2 f/gb s/tri/SGT962360/b/7/05/2002 surge current itsm (apeak) = f(t) for itsm =230a 1 10 1 0,1 0,01 0 50 100 150 200 250 0 t(s) itsm (apeak) fig.3 courbes de surcharge de courant / overload current curves 1 -itsm non r?p?titif sans tension r?appliqu?e est donn? pour la d?termination des protections. no repetitive itsm is given without voltage reapplied for the determination of the protection. 2 -itsm r?p?titif est donn? pour des surcharges de courant (tj initiale=70 c). la r?p?tition de ces surcharges de courant diminue la dur?e de vie du relais. repetitive itsm is given for inrush current with initial tj = 70 c. the repetition of the surge cur- rent decrease the lifetime ssr's . no repetitive itsm (apeak)=f(t) without voltage reapplied repetitive itsm (apeak)=f(t) with voltage reapplied for initial tj =70 c caract?ristiques thermiques / thermal curves : caract?ristiques de sortie(? 20 c) / output characteristics (at 20 c) param?tre / parameter conditions symbol typ. unit tension de charge / load voltage ue 400 v rms plage tension de fonctionnement / operating range uemin-max 24-600 v rms tension cr?te / peak voltage up 1200 v niveau de synchonisation / synchronizing level usync 24 v tension d'amor?age / latching voltage ie nom ua 10 v courant nominal ac-51/ ac-51 nominal current ( see fig. 2 ) ie ac-51 25 a rms courant de surcharge non r?p?titif / non repetitive overload current tp=10ms (fig. 3) itsm 230 a chute tension directe cr?te/ on state voltage drop @ ie nom vd 1,4 v courant de fuite ?tat bloqu?/ off state leakage current @ue, 50hz ilk 1 ma courant de charge minimum / minimum load current ie min 5 ma temps de fermeture/ turn on time uc nom dc ,f=50hz ton max 10 ms temps d'ouverture/ turn off time uc nom dc ,f=50hz toff max 10 ms plage de fr?quence / operating frequency range f 10-440 hz dv/dt ?tat bloqu? / off state dv/dt dv/dt 500 v/ s di/dt maximum non r?p?titif/ maximum di/dt non repetitive di/dt 50 a/ s i 2 t (<10ms) i 2 t 265 a 2 s emc test d'immunit? conduite / conducted immunity level iec 1000-4-4 (burst) 2kv criterion b emc test d'immunit? conduite / conducted immunity level iec 1000-4-5(schocks) 2kv crit.a with external vdr conformit? / conformity en60947-4-x
|